Programmation pour porte de garage

J'ai le système *HOMELINK dans ma Volvo puis je n'arrive pas à programmer ma porte de garage avec.. J'ai suivi les étapes, puis il n'y a rien qui ce passe, quand j'appuie sur la touche mon témoin lumineux clignote rapidement mais rien n'ouvre?

Il y aurait-il quelqu'un qui serait connaissant à ce sujet et pourrais me venir en aide?

Merci à l'avance

[rj240]

Votre Homelink est programmer, mais il faut ensuite ajouter la nouvelle "telecommande" a votre ouvre-porte-garage...

Phase 1

Be sure people and property, including yourself and your vehicle are NOT in the travel path of the garage door and that nothing will be struck when the door attempts to close or open !

Turn your vehicles ignition to the "Run" (or "accessory") position.
Hold the transmitter 1 - 3 inches away from the HomeLink buttons in you vehicle (do not block your view of the HomeLink indicator light)
Simultaneously press the transmitter button and the HomeLink button you wish to program (you may need two hands). Hold both buttons pressed until the indicator light changes from a slow flash to a rapid flash.
Rapid flashing indicates successful programming - Release both buttons (HomeLink and transmitter)
Press and hold the newly programmed HomeLink button,
If the indicator light is solid (not flashing) your garage door should now activate and you are complete. There is no need for Phase 2
If the indicator light flashes for 2 seconds before turning solid (not flashing) your garage door opener is rolling code technology and you must continue Phase 2 of these instructions.

Phase 2 - Only perform the following steps after successfully completing Phase 1.

A second person will make the following steps quicker and easier. Be sure people and property, including yourself and your vehicle are NOT in the travel path of the garage door and that nothing will be struck when the door attempts to close or open !

Locate the "Learn" (or "Smart") Button on the motor-head unit of your garage door opener. (This button is normally located on the back side, near the hanging wire antenna. Consult your manual for exact location.)
Fully press and quickly release the "Learn" Button (holding this button pressed for too long will erase all existing transmitters and keypads and they will need to be reprogrammed into the unit)
Within 30 second of pressing the "Learn" Button, return to the vehicle. Press the desired HomeLink button for 2 second, then release. Repeat this one step up to 3 times.
Your Garage door opener should now activate with a single press of the HomeLink button

Vous avez deja fait "Phase 1", il faut maintenant faire le "Phase 2"...

[wezo00]

Merci Roger! Je n'y arrivais pas moi non plus...

[rj240]

Merci Roger! Je n'y arrivais pas moi non plus...

Lol! C'est un question tres populaire ici...

[S60R_FREAK]

Un gros merci, je vais tenter le tout ce soir!

ton aide est très apprécié

[d-bock]

Be sure people and property, including yourself and your vehicle are NOT in the travel path of the garage door and that nothing will be struck when the door attempts to close or open !

J'adore l'entrée en matière!