J'ai acheté sur ebay une procédure pour éteindre la lumière de service sur un 850. Cependant je n'arrive pas à localiser le Diagnostic Test Port dont il est décrit. De là, je ne peux plus suivre la procédure et vérifier si celle-ci fonctionne correctement. Quelqu'un peut m'indiquer où se trouve ce port?
Voici la procédure:
Volvo 850 - V70 Service light reset procedure
Turn on the ignition to the KPll position so the warning lamps on the dash are illuminated. Do not start the car.
Open the bonnet and locate diagnostic test port behind the driver’s headlamp.
Remove the cover and pull the jumper wire out of the holder in the cover.
Insert the jumper into terminal #7 and then press button 4 times, wait approx 5 seconds and the red led should now glow continuously indicating that you are now into the data reset mode.
Press the button once and wait approx 5 seconds for the led to glow again then press the button 5 times. After about 5 seconds the led will illuminate again, press button 1 again and you should see the led flash repeatedly for a couple of seconds indicating that the service lamp has been reset.
If you have got it wrong just switch off ignition and start again.
Some 1996 model year vehicles
On these models the diagnostic port is in front of the gear lever. Switch the ignition on and under the speedometer upper site the trip reset button there is a rubber bung, remove this and with a thin pointer depress the pin, this should rest the light.
Voilà! Vous venez d'épargner 2.00$ US!!! :roll:
Voici la procédure:
Volvo 850 - V70 Service light reset procedure
Turn on the ignition to the KPll position so the warning lamps on the dash are illuminated. Do not start the car.
Open the bonnet and locate diagnostic test port behind the driver’s headlamp.
Remove the cover and pull the jumper wire out of the holder in the cover.
Insert the jumper into terminal #7 and then press button 4 times, wait approx 5 seconds and the red led should now glow continuously indicating that you are now into the data reset mode.
Press the button once and wait approx 5 seconds for the led to glow again then press the button 5 times. After about 5 seconds the led will illuminate again, press button 1 again and you should see the led flash repeatedly for a couple of seconds indicating that the service lamp has been reset.
If you have got it wrong just switch off ignition and start again.
Some 1996 model year vehicles
On these models the diagnostic port is in front of the gear lever. Switch the ignition on and under the speedometer upper site the trip reset button there is a rubber bung, remove this and with a thin pointer depress the pin, this should rest the light.
Voilà! Vous venez d'épargner 2.00$ US!!! :roll:
Commentaire